FTS-P100

FTS-P200 Broadband

FTS-P200 Dialup

Navigation Tools

• One FTS-W100 WiFi IP Phone with one battery
• One Charger
• One User Manual
• One Installation Guide
• One Standard and Extended Warranty

• Dimensions (L×W×H): 107.8 x 44 x 23.5 mm
• Weight: Approximately
• Battery: DC 3.6V 1500mAh Li-ion battery
• Charger
  • Input: 100~240V AC, 50~60Hz
  • Output: 5.2V DC, 600mA
• Charger Weight: Approximately 80g
• Charging Time: 3~4 hours
• Standby Time: 50~100 hours
• Talking Time: Approximately 5 hours
• Standby time refers to the state in which the phone is on continuously without being used for calls, or moved to different service areas.
• The standby time depends on the network conditions, phone usage and surrounding area. The phone consumes more battery power under the following conditions:
  • In areas with weak signals, with high or low temperatures, or when used outside the service coverage area.
  • When the phone frequently searches for network signal due to location changes.
  • When you talk on the phone for long periods of time.
  • The Alarm, Backlight or Vibration function is active.
  • Ring or listening volume is set to maximum.

1. Connect the charger to an AC wall outlet (100~240V).
   
2. Connect the lead from the charger to the charging socket of the phone. The battery indicator bar starts to scroll . If the phone is off, the text Charging is also displayed on the LCD screen.
3. When the battery indicator bar stops scrolling, charging is complete. The text Full Charged! is also displayed on the LCD screen, if the phone is off.

• The phone takes about 3~4 hours to charge and the exact time may vary depending on the circumstances.
• With your phone turned off, charge your new battery for 4 hours before its first use.
• When the battery is being charged, it is normal that your charger and phone become warm to the touch.
• If the phone is turned on while charging, you can still make and receive calls as usual, but this will consume battery power, thus extending the charging time.

1. In standby mode, switch the phone off by pressing and holding the off button. (Otherwise, some user settings will be lost.)
2. Remove the battery cover. With the back of the phone facing you, press the battery cover release button and lift the cover off in the direction of the arrow.
   
3. Remove the old battery. Disconnect the cord by firmly gripping the connector (not the battery connection wire) and pulling gently as illustrated.
   
4. Install the new battery. Connect the cord of the new battery by firmly inserting the connector into its place. Do not reverse the connector.
   
5. Replace the battery cover until it clicks into place.